Guest guest Posted December 24, 2010 Report Posted December 24, 2010 Just a simple project of winterizing the kitchen door. You may have seen commercials for that slider thing that fits under a door to cut down drafts? I bought one today and it really seems to work, even though mine is mounted vertically and not on the floor. The back kitchen door is crooked in the frame because of how the foundation settled. The draft didn't come under the door but from the lower part from the deadbolt to the floor. So, I cut the piece to fit by trimming the styrofoam tubes that make up the insulation part, put it on the door so the tube on the inside was flush to the door then stapled the material in place along the thickness of the door. The outer tube it pull over as far as it would go and used weatherizing tape to hold it in place to it would clear the door jam. Works like a charm. It left a little draft between the door latch and the deadbolt. So there I measure the gap and trimmed down one of the waste bits from the styrofoam tube. I measure from the edge toward the center and carefully carved out a kind of dome shapes rectangle, two of them. I then used weatherizing tape to hold them in place on the door and the dome tops just touch the door frame and the rounded nature doesn't interfere with the working of the door. End result: draft reduced to nearly nothing, save for just a tiny bit around the latch and deadbolt. Quote
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.