Jump to content
RemedySpot.com

I’m going to build DIY Chris Gupta Magnetic Pulser

Rate this topic


Recommended Posts

Posted

I'm going to build DIY Gupta Magnetic Pulser

http://www.newmediaexplorer.org/chris/2003/08/19/build_a_low_cost_simple_magneti\

c_pulser.htm

Couple of quesions:

1. It's written that: „Any SCR with PEAK current of at least 600 to 1000 amps

should work. The one shown is 20 amp continuous with the appropriate peak

rating... " . I checked the S6020L specs and the peak current is 250A. Why is

that? Is 250A enough?

2. I'm not sure about the Fig. 3 „Autopulse Circuit " : there is a switch and two

1Mohm potentiometers with „50% " and „70% " markings. Should this work as a switch

between different pulse (Hz) settings? Do " 50% " and " 70% " represent roughly 500

and 300kohms settings?

3. Is it a good idea to use separating transformer (1/1 ratio) on input for

increased safety? This trafo should have it's nominal power equal or greater

than the total power of light bulbs, right?

Join the conversation

You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...