Jump to content
RemedySpot.com

Re: Re: cell phone towers

Rate this topic


Guest guest

Recommended Posts

Marjij wrote:

>>> Are you in the US?

>>>

>> Yes, NE WA state.

>>

>>

>>

> Excuse me, but I can't tell from this exchange if it was Pamela or who

said they lived in NE WA state.

Sorry if it was not clear, I wrote the email, so it was me.

Oh that is clear as mud. I am typing... and I have lots of

pictures of NE WA on my webpage, so...

> I am thinking of moving to Chewelah, WA can either of you give me some

information about that area?

I've been in that area several times, and have studied the locations of

the hazards.

This summer I drove to Valley for hay, and only two months ago, I drove

Hwy 395 south to Spokane, with the Acoustimeter on the dashboard, and

the audio plugged into the truck radio/CD-in. Makes a nifty hands free

setup.

Starting in Colville, they just put up a new tower across from the

Walmart, so downtown is now very very bad. There are 3 towers on the

hill 1 mile north on Colville Mtn, and another tower 2 Mi SE on

Huckleberry Range Paradis Peak.

Also the local AM radio tower is 1 Mi. south in the valley floor.

I wrote down 0.54 V/m for Colville on the Acoustimeter, and on the

Cornet, 0.258 mW/m2 outside the Walmart, and 4.807 mW/m2 inside Walmart,

nearest the check out computers using WiFi, and the shelfing workers

with their WiFi scanners. Avoid them like a plague! That is very much in

the red zone.

(I have a conversion table on my webpage.)

Heading south 6 miles is Arden, and from here south it is actually

fairly quiet for the next 8 miles to Addy, <0.02 V/m. Then I started

picking up a cel-tower again.

I located it when passing Blue Creek intersection 3 Mi south of Addy,

there is a new tower just west 3/4 mile on the hill just opposite of,

(south of) Rieckers Mtn. It was not there last year. I didn't write down

any numbers, as I was on the highway, and didn't aim the meter at the tower.

Continuing southeast, 5 Mi to Chewelah, the tower west of Chewelah

becomes visible, and audible as the whine grows steadily. It is on the

first hill west of the valley, but I can't remember which hill that was.

Maybe Pine Hill. It looks like I forgot to update my map after that last

trip... I think it is less than 2 years old.

Downtown Chewelah, I wrote down 0.34 V/m. Only in the yellow zone.

Fairly small bubble in radius. Worry more about the above tower than

downtown stuff.

South 1 mile, I got a large spike near the casino on the east side of

Hwy395. I looked around hard, but couldn't see any towers to explain it.

I didn't write down any numbers, but it was memorable.

The next several miles past Jumpoff Joe Mtn, it is fairly quiet again,

<0.02 V/m, as the surrounding hills provide good shading. I also found

it fairly quiet south of Valley to Springdale where I got hay this year.

Approaching Loon Lake, there is a tower on top of Deer Lake Mtn, east

one mile of Hwy. From here south, there is no " quiet " on the meter, it

is always buzzing and whining, with the intensity going up and down

between towers etc.

Approaching Clayton, I started picking up the radar from Spokane

Airport, I noted 0.69 V/m at Clayton, every 11 seconds.

From there south, the number of towers increase as you (or I) approach

Spokane.

There are 2 towers very close to, and in Deer Park. Right next to the

Hwy. 0.87 V/m getting deep into the red zone again at the peak nearest

those towers.

Driving through Spokane is one tower after another, 2 V/m.

One other measurement to share for Spokane, passing the Sears building

on Division St, opposite a tall banking building, it has many antennas

on top, I measured 4.07 V/m. That is seriously bad, and it really hurt.

Back north to Chewelah, back in summer, when dad drove west with me on

the Cedona-Addy Rd, I found the radio tower, and other towers on top of

Stensgar Mtn blanketed that valley just to the north, I remember it

showing up on my Zap Checker, but less so on the others. Acted more like

an analog wave than a digital noisemaker. Dad thought those valleys

might provide good protection from Spokane, with a warmer growing

climate than here, but it didn't pan out. Second place he thought might

work is a bit north in Swiss Valley. I was not feeling well enough to

get excited about more exploring.

I was pleasantly surprised to find those 2 quieter areas. The thing that

bothers me about moving to Arden-Addy or Valley-Springdale, is it is

more populated than here. But with several neighbors here broadcasting

WiFi, the numerical statistic of 2 people per sq. mile just isn't what

it used to be.

Looks like I wrote a short book. Hope you find it educational, and helpful.

> Cell danger? Thanks,

>

> Marji

>

>

>

> ------------------------------------

>

>

Link to comment
Share on other sites

This is for Marjij,

 

 Hi thanks for replying to my question. Let me see if I get this right:

is in NE WA.  Where

>>> Are you in the US?

>>>

>> Yes, NE WA state.

>>

>>

>>

> Excuse me, but I can't tell from this exchange if it was Pamela or who

said they lived in NE WA state.

Sorry if it was not clear, I wrote the email, so it was me.

Oh that is clear as mud. I am typing... and I have lots of

pictures of NE WA on my webpage, so...

> I am thinking of moving to Chewelah, WA can either of you give me some

information about that area?

I've been in that area several times, and have studied the locations of

the hazards.

This summer I drove to Valley for hay, and only two months ago, I drove

Hwy 395 south to Spokane, with the Acoustimeter on the dashboard, and

the audio plugged into the truck radio/CD-in. Makes a nifty hands free

setup.

Starting in Colville, they just put up a new tower across from the

Walmart, so downtown is now very very bad. There are 3 towers on the

hill 1 mile north on Colville Mtn, and another tower 2 Mi SE on

Huckleberry Range Paradis Peak.

Also the local AM radio tower is 1 Mi. south in the valley floor.

I wrote down 0.54 V/m for Colville on the Acoustimeter, and on the

Cornet, 0.258 mW/m2 outside the Walmart, and 4.807 mW/m2 inside Walmart,

nearest the check out computers using WiFi, and the shelfing workers

with their WiFi scanners. Avoid them like a plague! That is very much in

the red zone.

(I have a conversion table on my webpage.)

Heading south 6 miles is Arden, and from here south it is actually

fairly quiet for the next 8 miles to Addy, <0.02 V/m. Then I started

picking up a cel-tower again.

I located it when passing Blue Creek intersection 3 Mi south of Addy,

there is a new tower just west 3/4 mile on the hill just opposite of,

(south of) Rieckers Mtn. It was not there last year. I didn't write down

any numbers, as I was on the highway, and didn't aim the meter at the tower.

Continuing southeast, 5 Mi to Chewelah, the tower west of Chewelah

becomes visible, and audible as the whine grows steadily. It is on the

first hill west of the valley, but I can't remember which hill that was.

Maybe Pine Hill. It looks like I forgot to update my map after that last

trip... I think it is less than 2 years old.

Downtown Chewelah, I wrote down 0.34 V/m. Only in the yellow zone.

Fairly small bubble in radius. Worry more about the above tower than

downtown stuff.

South 1 mile, I got a large spike near the casino on the east side of

Hwy395. I looked around hard, but couldn't see any towers to explain it.

I didn't write down any numbers, but it was memorable.

The next several miles past Jumpoff Joe Mtn, it is fairly quiet again,

<0.02 V/m, as the surrounding hills provide good shading. I also found

it fairly quiet south of Valley to Springdale where I got hay this year.

Approaching Loon Lake, there is a tower on top of Deer Lake Mtn, east

one mile of Hwy. From here south, there is no " quiet " on the meter, it

is always buzzing and whining, with the intensity going up and down

between towers etc.

Approaching Clayton, I started picking up the radar from Spokane

Airport, I noted 0.69 V/m at Clayton, every 11 seconds.

From there south, the number of towers increase as you (or I) approach

Spokane.

There are 2 towers very close to, and in Deer Park. Right next to the

Hwy. 0.87 V/m getting deep into the red zone again at the peak nearest

those towers.

Driving through Spokane is one tower after another, 2 V/m.

One other measurement to share for Spokane, passing the Sears building

on Division St, opposite a tall banking building, it has many antennas

on top, I measured 4.07 V/m. That is seriously bad, and it really hurt.

Back north to Chewelah, back in summer, when dad drove west with me on

the Cedona-Addy Rd, I found the radio tower, and other towers on top of

Stensgar Mtn blanketed that valley just to the north, I remember it

showing up on my Zap Checker, but less so on the others. Acted more like

an analog wave than a digital noisemaker. Dad thought those valleys

might provide good protection from Spokane, with a warmer growing

climate than here, but it didn't pan out. Second place he thought might

work is a bit north in Swiss Valley. I was not feeling well enough to

get excited about more exploring.

I was pleasantly surprised to find those 2 quieter areas. The thing that

bothers me about moving to Arden-Addy or Valley-Springdale, is it is

more populated than here. But with several neighbors here broadcasting

WiFi, the numerical statistic of 2 people per sq. mile just isn't what

it used to be.

Looks like I wrote a short book. Hope you find it educational, and helpful.

> Cell danger? Thanks,

>

> Marji

>

>

>

> ------------------------------------

>

>

Link to comment
Share on other sites

Join the conversation

You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...