Guest guest Posted September 27, 2004 Report Share Posted September 27, 2004 Hello, this equeation does not work. You can't know what ferquencies are radiating from this thing. The damaging part are the magnetic fields emanating. And we know that they can be heavy. Especially above the keyboard, whereunder the hard disk and motherboard are placed. My CRT monitor radiates hard with 91.1 kHz, but I found many other frequencies. You may hold a world receiver in front of your laptop. Greetings, Claessens member Verband Baubiologie www.milieuziektes.nl www.hetbitje.nl checked by Norton Antivirus shielding Notebook > > Date: Sun, 26 Sep 2004 11:09:02 -0000 > > > > Hello, > > > > I am thinking of shielding my Notebook. Maybe with paint or with > > wallpaper on its outside. I tested and know shielding it will help. > But I do > > not know If there can occur problems when I do it. > > > > > > Randolf Weinand > > > > > > Quote Link to comment Share on other sites More sharing options...
Guest guest Posted September 27, 2004 Report Share Posted September 27, 2004 Hi , The niacin and folic acid therapy was targetted towards improving overall health and depression, but had possibility of helping EMF sensitivity. I have been fortunate to have reduced nerve pain & headaches as a result, which reduces EMF sensitivity - I'm allot more productive as a result. I am curious about the Bioprotect device. I have to space out how much money I spend on EMF gadgets, but I'm sure I'll get one sooner or later. I have done almost everything I could find in the past 4 months. The root cause of my problem seems to be rooted in my 7 amalgam mercury fillings I had replaced 5 months ago. Since then I have been lucky to find one naturopath, and two medical doctors specializing in dealing with mercury, and have completely turned my life upside down. I now have a very strict diet of foods that support healing (cut out everything that is commonly known to be bad - sugar, white flour, caffeine, dairy, etc). Its difficult to say exactly what has worked, since for me " life balance " with the right stuff seems to be my key. * I use SpringLife Polarizer on my notebook, hang Aulterra Neutralizer as necklace, and have Quantum Home plugged into electrical system - Quantum seems to have biggest impact on getting a good melatonin cleanse at night since my sleep & energy are dramatically improved. EMF is known to reduce effectiveness of melatonin if one sleeps with too much EMF. I have Quantum Byte software on my notebook, but can't notice any difference with computer EMF or stress .. * Mercury detox: DMSA with Cilantro, and DMPS with Cilantro. Sometimes I add in chlorella, but I seem to feel not as great when I take chlorella so don't use it as often. There is controversy about which way is best to detox. My latest information tells me we detox naturally if we have enough glutathione. My past email shows how to boost glutathione. Detox of Mercury in brain and some organs requires DMSA to get it out. * I quite black and green teas since they are loaded with flouride which slows thyroid production. I also quit using flouride toothpaste. * Became a pranic healer to rebalance my bodies energy field to reduce symptoms. * Practice Medicine Buddha regularly, listening to CD and going to temple once a week. The frequncies of the chants and instruments helps settle and recharge my energy system. * I use coconut oil or butter on flax bread to help my thyroid & improve metabolism. * I drink 3 shakes a day of USANA (Olympic grade nutrition - but expensive. My wife is a USANA manager so I get a good deal on it). USANA is like a linus blanket for me - giving me relief everytime I drink it. I eat their nutrition bars like candy since they quench cravings and are good nutrition. * I take Salmon oil to reduce neurological side effects from mercury. I take Evening Primrose Oil - supposed to be good for EMF. * I do affirmations telling myself I feel great when I feel terrible. * I do monthly Shiatsu to balance energy meridians. * I walk as often as possible to get my energy field flowing. * I tie it all together with faith, knowing I will eventually get better, and just riding out the waves as they hit me. I find that the toughest challenge. Wayne Dyer has an amazing book " There's a spiritual solution to every problem " , which gives me great hope in my recovery. * If you have a thyroid challenge, the Buddhist chant " Om " and " Ah " are very good for thyroid. I play a CD full of repetitive " Om " anytime I feel scattered energy, or when I can't focus on reading. It calms my nervous system like magic. My goal is complete freedom from EMF symptoms. I may achieve this through tolerance with a stronger body, or emf protection devices. I'm trying both ways at once. All in all, I feel a bit obsessive in my pursuit, but that is just my nature. Perhaps I would get better with only half of what I am doing. It seems to give me a lifestyle since I'm not able to work. ie. keep me busy doing all these special things and looking for solutions so I don't focus on my symptoms. On the flip side it has all been a gift in disguise, since I am developing a very extensive website to help simplify this process for others. It took me 5 years to have a clue about my problem. I believe people should find these types of solutions much more rapidly, so that is my new dream. I have the vision and the technical knowledge so it will happen, once EMF lets me stay at my computer long enough. Regards, Glenn ----Original Message Follows---- From: " Fancy " <davidfancy@...> Reply- Subject: Re: shielding Notebook Date: Mon, 27 Sep 2004 00:37:30 -0000 Hi Glen, How's the niacin and folic acid experiment going? I'm seeing my naturopath tomorrow and will run that by her as a possibility. Anything else really working? I suspect Dietrich was referring to the Bioprotect devices he has developed. I've just ordered some, I'll let you know how it goes. Best > >being a member of this group for some time, you should think of a simpler > >solution to protect you against the radiation of your notebook. There are > >enough > >hints in this list. > > Dear Dietrich, > > I have tried a number of the solutions, namely Quantum Home, Aulterra > Neutralizer, SpringLife Polarizer, and diet. None seem to eliminate the EMF > enough to get complete freedom from it at my computer. I always seem to > have to fight with illness to work at computer. > > So I finally thought that creating a complete barrier between source and > myself may be a good solution. > > I look at it as stepping outside the box for a moment and taking a new > approach. > > I sense that although many people are getting allot of relief with methods > in this list, nobody has shown complete relief. That is my goal. Perhaps > that will only happen with a non-EMF environment. > > Regards, > > Glenn Quote Link to comment Share on other sites More sharing options...
Guest guest Posted September 30, 2004 Report Share Posted September 30, 2004 Hello Beau, I still maintain my meaning about those equations. Let me go further. I think it is a lot of bullshit. No pun intended, but you cannot calculate the shielding effect. You can only MEASURE the shielding effect, and must do that with several different frequencies. As is done by prof. i of the University of the Bundeswehr (Army) in Germany. He is the authority for testing shielding materials. And a lot of materials do react sometimes quite differently as expected! The placing of a shielding material related to the source and related to the person is also very important. If the shielding is too close to the person, it can even raise the elektrosmog. That can be the case with those Baldachins around the bed, where by *Ankopplungsspannungen* the body tension can raise enormously. And in some ways the shielding material can also reinforce the incoming radiation. But a shielding material is not enough. We have to look very hard at the longitudinal waves, which pass right through shieldings. (Here the other *things*, as mentioned in this group, come into focus. They all have their working related to longitudinal waves) It is an overwhelming new terrain. But the answers to several questions raise much more new questions. I realise, that for many of you, this item sounds like something out of Star Trek, but it is a reality now, and explains a lot of what is happening and why it is happening to many of us. Greetings, Claessens member Verband Baubiologie www.milieuziektes.nl www.hetbitje.nl checked by Norton Antivirus shielding Notebook > > > > Date: Sun, 26 Sep 2004 11:09:02 -0000 > > > > > > > > Hello, > > > > > > > > I am thinking of shielding my Notebook. Maybe with paint or with > > > > wallpaper on its outside. I tested and know shielding it will > help. > > > But I do > > > > not know If there can occur problems when I do it. > > > > > > > > > > > > Randolf Weinand > > > > > > > > > > > > > > > > > > Quote Link to comment Share on other sites More sharing options...
Guest guest Posted September 30, 2004 Report Share Posted September 30, 2004 " Imagine our situation if this signaling is added to the environmental mix directly through our home wiring. " Hi Beau, I read an article somewhere that said that those children who did live near power lines and contracted leukemia were predominantly near power lines that had signals traveling over them, whereas children that were living near power lines that were not affected were mostly living near power lines with no control signals.. I'll see if I can find it.. it might have been http://www.emfacts.com/, anyhow there is potentially a world of hurt coming towards us in the situation you mention..! Cheers Pete Beau wrote: > Hey , > > What type of broadband technology are you using to connect to the > Internet, DSL or a cable modem? If you're using a phone-line based > technology like DSL, all the phone lines associated with a particular > phone number in your house are probably getting signals continuously > from the broadband network since it is always active. I think the > same issue would hold for a cable modem. > > When the modem is off and you still sense the difference is the > computer also off? If the computer is on, did you have to install a > new network interface card (NIC) in your computer before you began > using the modem, or did you have to enable your motherboard's > built-in ethernet interface? If so, the NIC or onboard ethernet may > be the issue. If the computer is also off, my first guess would be > the consistent broadband signaling on your home phone lines or cable. > I'd try disconnecting the phone/cable company's feed into your home > and see if the situation clears up for you. > > This reminds me -- keep your eyes peeled for BPL (Broadband over Power > Lines). I've heard from Roy Beavers that the power companies already > send signals over the grid for monitoring and maintenance. Now they > want in on the Internet money stream and are trying to use the grid > for broadband Internet connectivity. The remaining obstacle to > mainstream implementation that I know of is the short-wave radio > interference BPL transmissions have been shown to cause in some areas. > Imagine our situation if this signaling is added to the > environmental mix directly through our home wiring. > > All the best, > Beau > > > > > I;ve been using what I think is aluminum window screen warpped in > > various folds around a throublesome modem. This has cut down the RF > > emissions significantly, according to the Field Strength Meter. I've > > also sent it packing to the other end of my house with a 50' > > ethernet cable. I can still notice a difference when its actually > > turned off. Is there some way that the 50 cable is in some fashion > > acting as an antenea for the modem's unblocked RF output? > > > * Quote Link to comment Share on other sites More sharing options...
Guest guest Posted September 30, 2004 Report Share Posted September 30, 2004 Hello Beau, I just wanted to point out, that 1. how nice the calculations may be, measurements show differently. The occurring frequencies play an important role also. 2. longitudinal waves go right through shieldings. Some shieldings even reinforce the destructive workings of longitudinal waves. It is even possible to neutralise or alter or influence those destructive workings of longitudinal waves without any shielding. We still have a lot of study end investigation in front of us. Greetings, Claessens member Verband Baubiologie www.milieuziektes.nl www.hetbitje.nl checked by Norton Antivirus shielding Notebook > > > > > > Date: Sun, 26 Sep 2004 11:09:02 -0000 > > > > > > > > > > > > Hello, > > > > > > > > > > > > I am thinking of shielding my Notebook. Maybe with paint or > with > > > > > > wallpaper on its outside. I tested and know shielding it > will > > > help. > > > > > But I do > > > > > > not know If there can occur problems when I do it. > > > > > > > > > > > > > > > > > > Randolf Weinand > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.