Guest guest Posted May 2, 2004 Report Share Posted May 2, 2004 A couple of you are having problems right now. Here is some information I have about our experiences with the DBB and pressure sores (start like a dark/purple spot/bruise). Blisters also turn into sores - which is why it is most important to get the shoes on right so they don't cause sores and blisters. Most important is to get the shoes on properly and do what you have to to stop sores from forming. So, if the pressure spots (dark) get worse or don't go away something is wrong and it will never get better till you stop the pressure in that area. Blisters are caused by slipping or friction on a spot on the foot, stop the slipping with making sure the boots are on tightly and the heel seated deep in the bottom of the shoe. I hope there is some answers to your problems with the new babies in the DBB. I remember this time very clearly and it was not fun at all. Most importantly - Listen To Your Baby. S/He will tell you if there is something wrong, and you must trust your instincts and not make things worse by letting a sore get worse. You can get past sores, many of us have done it but it is best to not get them in the first place. Big Hugs to you parents dealing with this. It will get better - the moment we fixed the problem our daughter couldn't have been happier in the DBB. What a difference! Kori Darbi 3/03 Rt. CF - DBB 12hr/d How to put Markell Open Toe Boots attached to Brace FAB/DBB (Foot Abduction Brace/Dennis Browne Bar) Before you put the shoes on the first time: Take the laces out and tie a knot in the middle. Then re-lace the shoes. Tie a knot at the very ends of each lace end so they don't come out of the holes. This has been a lifesaver for us - we never have to re-lace them and can pull them very loose to get the shoes on. The knot in the middle shows us that they're even each time so I never worry about one side being longer than the other. I love this tip! Consider slitting the tongue keeper slit up to the top of the tongue. This allows the tongue to sit low on the top of the foot - and allows the top of the boot to be tightened up on the ankle enough so the fatty baby calf doesn't pull the heel up and out. The tighter the ankle, the better seated the foot will be. We find it easier to have the straps and buckles on the inside rather than the outside. Since the feet are pointed out in the first place cinching them up on the inside is just easier in general. Straight Last shoes can be installed on either side of the DBB - as they are not a right or left shoe. The Ponseti Method uses straight last shoes although sometimes a baby will get reverse last. If you got reverse last shoes ask about the straight last shoes. Install the strap in the lower hole on each side of the boot. Apparently this is the best position to keep the foot in the shoes. Medium thickness cotton socks are recommended. We like the Old Navy or Gymboree socks with the rubber grips on the bottom. They are regularly 7 for $10 at Old Navy. I suggest you get at least 7 if not more. They seem to get lost in the laundry... and it's not fun trying to find that perfect sock when you need it. Plus you can make sure you've got the right colors on hand for accessorizing :~} In the winter after the initial first few months of getting used to the DBB and worrying about slipping I use tights. Not only for girls - I put my non-clubfoot boys in tights (white, black or blue of course!) in the winter too - it helps keep their legs warm when their pants hike up while being carried outside. But tights work very well with the DBB in our experience. The thicker the better, make sure they're stretchy so they fit the feet nice and tight. Remember - when you first get the DBB take it off every 2-3 hours to check the feet for sores or red marks that don't go away. Leaving the brace on for longer periods of time if baby seems happy is fine. If baby is showing signs of distress take the shoes off and inspect the feet. Then use the following instructions and re-install the brace. You should check the feet often over the first couple of days or more if baby is showing signs of distress. If you do not see signs that sores or blisters are forming things are ok - keep the brace on. Installation tips (how to put the DBB on a wiggly little baby without causing pain or sores) 1- If you can - take the shoes off the bar. If you have a gold bar this is simple. You may have to use a wrench or pliers to get it off the first time as some brace shops really tighten them up. Don't loose the nut. It is best to put the nut back on the shoe after you take it off the bar - as it helps keep them around and getting kicked in the thighs without that nut there really hurts! Mark on the plate where your shoes are to be set at with a Sharpie marker. This makes it very easy to put them back in the right spot - even in low light. If you have the red adjustable bar it is harder to take the shoes off, maybe not possible. But if you can, try it. I really feel it's a better way than trying to put the shoes on with the bar. 2- Loosen the laces up all the way to the knots and pull the tongue up as well. If you have short straps, buckle the strap into the last hole loosely so as not to pull it out when the foot goes in. The longer straps don't need to be buckled. 3- With the shoe off the bar insert the foot into the shoe and bend the knee 90 degrees. Push on the top of the knee and hold the sole of the shoe. Press the heel deeply into the back of the shoe and flex the toes upward (dorsiflexion) as far as possible. Keep pushing on the knee and flexing the foot and make SURE the heel is seated well into the bottom and back of the shoe. 4- With the knee still bent and pressure applied press with your thumb or other convenient finger on the strap where it goes through the tongue keeper slit and hold the heel into the back of the shoe and tighten the strap. Buckle it tightly. Dorsiflex the foot again and press again on the knee and sole of the shoe to make sure the heel is in properly. Re-tighten the strap very tight. If the heel is down you can't tighten it too much. If there is any wiggle or looseness press the foot into the shoe again push with your thumb on the strap and re-tighten the strap again. It must be very tight - tighter than you would imagine it needs to be. So keep going till it's really tight. 5- Pull the sock at the toes to make sure the seams aren't going to press into baby's toes - it also helps make sure the heel is seated. It's ok if they look all bloused out in front. This is good - gives baby room to wiggle toes and who cares how it looks anyway! 6- Pull the tongue way down over the toes. As far as you can. I prefer it to sit *under* the top of the boot at the ankle just a little bit. If it sits high you may need to cut the tongue keeper slit a little more. (don't cut it above the stitching) 7 - Tighten the laces nice and snug all the way up and tie them. The shoe should get tighter with the laces being tightened. 8- Check to see if the foot can slip out of the boot at all. If it moves it'll loosen up with time and slip. If it's not tight repeat the above instructions with emphasis on the pressure on the knee and pushing the heel into the bottom of the shoe with the foot flexed up (toes pointing toward the baby's head) all at the same time. This isn't easy at first, but you will get used to it and very good at it in short time. 9- Repeat the procedure with the other boot. 10- When both boots are on - take the nuts off and put the bar back on. If your baby is bi-lateral it doesn't matter which side you do first. If baby is unilateral it's easier to put the clubfoot side on first as the other side set at 45 degrees is easier to put on the bar second. Signs of trouble: Baby cries a very unnatural (for your baby) unhappy in pain cry all the time, kicks legs violently like she's trying to kick the shoes off, wakes at nigh every half hour or less (other than being hungry), purple/black marks on the heels or other parts of the foot, blisters form or sores form. All these are typically caused by the shoes not being on properly. If pressure sores or blisters appear - you MUST fix whatever is causing the problem before you put the shoes back on. Sores will not heal in the shoes once they appear (skin falls off and actual sore is resident - as opposed to just a purple or black mark). It might mean a trip back to the Dr. for a healing cast. Which is ok - it keeps the correction while the sore heals. You MUST find out why the sore came - if it's slipping or pressure or whatever - find it and fix it. When you go back to the DBB follow the above directions and make SURE the heels are down 100% in the bottom of the shoes. Blisters are caused by friction or rather slippage. Slippage is often caused by the strap not being tight enough. It may seem tight enough, but if slippage happens it very likely is not tight enough. If the heel is rising up it seems tight but once you get the heel down you'll find you can tighten it up another couple of holes. Dorsiflexing the foot while you put the shoes on really helps prevent this. After having persistent sores some parents have resorted to actually cutting a large hole in the heels of the shoes. This helps to relieve pressure so that baby can continue to wear the DBB while a sore heals. It is not a long term fix. The foot must be in the shoe properly for long term wear. However, after cutting the hole many parents have found that they were not getting the heel down all the way and were then able to see to make sure the heel is down. I don't recommend this - it is a short term bandaid to the larger problem of proper fitting of the shoes. However it is a good option to going back to casts for healing and starting again with the 23/7 schedule for wearing the FAB. The shoes will not fall apart and are essentially disposable as they can only be worn for a few months till baby needs a larger size. For more information about this you can contact me personally - frogabog@... and I can help you find a solution to healing your child's sores. We have endured this and hope to not see any other babies have to go through this pain and unhappiness. Remember - there is a light at the end of the tunnel and you can find a way to keep the FAB on so your baby can take advantage of the most effective brace to complete the non-surgical treatment. Other reasons why baby may be uncomfortable are: skin sensitivity right after casts are taken off. This is unfortunate, but will get better with time. Don't rub the legs - this hurts more. A little lotion is ok but keep it off the feet itself as it can cause slipping. Bar is too long or too short. The heels of the shoes (fixed on the bar in the correct positions - 70 degrees for a clubfoot and 45 for non clubfoot) should be shoulder width apart. Any less or more is uncomfortable for baby. It is not the length of the bar - it is the distance between the heels. Take the brace and place it up to baby's shoulders to check this. Foot is at the wrong position. The clubfoot should be at 70 degrees or *AT LEAST* as far turned out as the last cast. Parents - save your last cast. Take that cast and put it up to a protractor with the knee pointed to 0 degrees and see where the midline of the foot portion points to. Then set your DBB. If it is much less than 60 degrees consider talking to your doctor about another cast. The last cast in the Ponseti Method should be at 70 degrees. If your cast is not there, and your doc doesn't see fit to re-cast you can try to get there slowly over time. Set your brace to where the cast is set at and slowly once a week increase it by 5 degrees. Do not put the foot further out than the last cast as this causes considerable discomfort for the baby. Baby is irritated by not being able to move legs independently. You can show baby how to move his legs together. They might not like this at first but will soon learn to lift their legs up with the brace on. This is minor irritation for the baby. They get used to this fairly quickly. It is very important to not take baby out of the brace. Do everything you can to make sure your baby stays in the brace. But listen to your child and follow your heart. If you see signs of sores there is a problem you need to tackle and rectify. Do NOT keep a brace on a child who has a weeping sore. This is painful and you wouldn't put a tight shoe on your own foot with a sore like that. If your child is telling you she's in pain she likely is and you need to find out why. Do what you can to keep the brace on - but don't make a bad situation worse by putting it on incorrectly and causing sores. See your Dr. about healing casts or cut a hole... but don't make sores worse. If your baby is irritable at first consider co-sleeping so everyone gets some sleep the first few nights. You can side lie and nurse a baby wearing the dbb, it's a little different than a baby who doesn't wear one but is absolutely doable. Even if you only do this for a few days while baby is getting used to the brace - it will help everyone in your family get sleep the first few nights. Put a pillow under baby's feet. It is easy enough for baby to side lie in the DBB with a pillow under his feet. Good luck and don't forget to post to the list if you need help. We're here for you and have lots of different takes on how to make the shoes and bar work so there's lots of different ways to work through problems. ********************************************************************************\ ***** ok - work in progress but this may help some of you out there who need tips right now and I need to do something else right now. I will post this in the files section when I'm finished with it and satisfied it's complete. I welcome any and all critiques of this as well as any additional tips I may have forgotten. Please post to this topic for now and I will compile them into the single file at a later date. Kori Mama of Kenton - 6/98 Merek - 3/00 Darbi - 3/28/03 - Rt. CF - DBB 12hr/d (¨`·.·´¨) `·.¸(¨`·.·´¨) `·.¸.·´ Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.