Guest guest Posted May 17, 2011 Report Share Posted May 17, 2011 Pete, Uwe, I’m attaching a revised, simpler and easier to use version of the Design which does have those In2 connections made. Originally, they were there. Here’s what happened. In trying various ways to simplify the Design I had disconnected them at one point and inadvertently discovered that things worked without them. I forgot at that point that in BioExplorer disconnecting Design objects in the Signal Diagram does not necessarily mean that they stop working altogether. Certain hidden connections may remain active in BioEx even after they have been removed in the Signal diagram. For example, sound producing objects may still work after connections have been removed. So I sent the Design out thinking it was OK. But closing down BioEx will break those hidden connections. So, sure enough after getting your emails, when I fired up BioEx again, the Design, now it didn’t work here either. Larry From: pvdtlc Sent: Saturday, May 14, 2011 3:22 PM Subject: Re: BAUD The Expressions 1 and 2, coming out of the Buttons 1 and 2 say that if the button is pressed ON (In1=1), then the output should be In2, but there is no input into In2. By removing the arrows from Out on these expressions to Enable on the Tone Generators, the sound is heard; otherwise it is not. I don't understand the Enable requirement coming from an expression (unless it only outputs 0 or 1).Pete- Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.