Jump to content
RemedySpot.com

Re: Tent Sauna Thermostat

Rate this topic


Guest guest

Recommended Posts

> Can any users of Den's tent sauna comment on the need for a

thermostat

> to control the temperature? I am thinking of hooking up an oven

> thermostat to cycle on & off the steam pot to maintain a preset

> temperature. Without the thermostat the steam generator stays on

all the

> time.

>

> Thanks,

>

> Dennis

Unless Dens steamer has greatly improved over the last few years, I

would discard it as he suggested to me a few years ago - junk.

I ended up using a 6 gallon electric water heater with a fast

response remote bulb temperature controller inside the sauna cabinet

and a ground fault detector for insurance. Only the probe is in the

sauna. If I want more heat, I just touch the element with my hand,

if I want less, I let go.

Dick

Link to comment
Share on other sites

Dick,

Is the " fast response remote bulb temperature controller " a special kind

of thermostat? I have found some remote bulb thermostats but I'm not

sure about the fast response aspect.

I agree that the steamer is cheaply made but did you find that it didn't

do the job?....Not enough steam?

Is the 6 gal electric water heater you use an off the shelf product?

Dennis

bjs17792001 wrote:

>

>

>

>>Can any users of Den's tent sauna comment on the need for a

>>

>>

>thermostat

>

>

>>to control the temperature? I am thinking of hooking up an oven

>>thermostat to cycle on & off the steam pot to maintain a preset

>>temperature. Without the thermostat the steam generator stays on

>>

>>

>all the

>

>

>>time.

>>

>>Thanks,

>>

>>Dennis

>>

>>

>

>Unless Dens steamer has greatly improved over the last few years, I

>would discard it as he suggested to me a few years ago - junk.

>

>I ended up using a 6 gallon electric water heater with a fast

>response remote bulb temperature controller inside the sauna cabinet

>and a ground fault detector for insurance. Only the probe is in the

>sauna. If I want more heat, I just touch the element with my hand,

>if I want less, I let go.

>

>Dick

>

>

>

Link to comment
Share on other sites

I have done over 300 saunas in Den's sauna with the " junk " boiler and found it

to be adequate. the only complaint I have is that sometimes the steam can

direct itself directly onto your butt and can burn and the leakage through the

bottom of the tent can cause damage to a carpet. I have bought one of those

trays for under a washing machine and cut the poles so that it fits into the

tray, making life much simpler. Also, several towels on the bottom can ease the

problem.

I sure would love one of Saul's fiberglass units but not able to yet!

Best wishes and much love, Ken

Ken Gullan

Institute for Research Integration (IRI)

San Diego, CA 92106-2424

IRI is a 501C(3) non-profit corporation established to help children with

developmental difficulties.

To contact me off-list use kengullan@... or call 619-222-1104

Re: Re: Tent Sauna Thermostat

Dick,

Is the " fast response remote bulb temperature controller " a special kind

of thermostat? I have found some remote bulb thermostats but I'm not

sure about the fast response aspect.

I agree that the steamer is cheaply made but did you find that it didn't

do the job?....Not enough steam?

Is the 6 gal electric water heater you use an off the shelf product?

Dennis

Link to comment
Share on other sites

Ken,

Why don't you try slipping a length of flexible tubing over each of the

" Y " steam inlet pieces?

They measure 7/16 " diameter.

You could then direct the steam away from your body.

Dennis

Ken Gullan - IRI wrote:

>I have done over 300 saunas in Den's sauna with the " junk " boiler and found it

to be adequate. the only complaint I have is that sometimes the steam can

direct itself directly onto your butt and can burn and the leakage through the

bottom of the tent can cause damage to a carpet. I have bought one of those

trays for under a washing machine and cut the poles so that it fits into the

tray, making life much simpler. Also, several towels on the bottom can ease the

problem.

>I sure would love one of Saul's fiberglass units but not able to yet!

>Best wishes and much love, Ken

>

>Ken Gullan

>Institute for Research Integration (IRI)

>San Diego, CA 92106-2424

>IRI is a 501C(3) non-profit corporation established to help children with

developmental difficulties.

>To contact me off-list use kengullan@... or call 619-222-1104

> Re: Re: Tent Sauna Thermostat

>

>

> Dick,

>

> Is the " fast response remote bulb temperature controller " a special kind

> of thermostat? I have found some remote bulb thermostats but I'm not

> sure about the fast response aspect.

>

> I agree that the steamer is cheaply made but did you find that it didn't

> do the job?....Not enough steam?

>

> Is the 6 gal electric water heater you use an off the shelf product?

>

> Dennis

>

>

>

>

Link to comment
Share on other sites

Good suggestion but was only a problem for first few saunas and got used to it!

Too lazy for little return. Thanks though! :-)

Best wishes and much love, Ken

Ken Gullan

Institute for Research Integration (IRI)

San Diego, CA 92106-2424

IRI is a 501C(3) non-profit corporation established to help children with

developmental difficulties.

To contact me off-list use kengullan@... or call 619-222-1104

Re: Re: Tent Sauna Thermostat

Ken,

Why don't you try slipping a length of flexible tubing over each of the

" Y " steam inlet pieces?

They measure 7/16 " diameter.

You could then direct the steam away from your body.

Dennis

Ken Gullan - IRI wrote:

>I have done over 300 saunas in Den's sauna with the " junk " boiler and found

it to be adequate. the only complaint I have is that sometimes the steam can

direct itself directly onto your butt and can burn and the leakage through the

bottom of the tent can cause damage to a carpet. I have bought one of those

trays for under a washing machine and cut the poles so that it fits into the

tray, making life much simpler. Also, several towels on the bottom can ease the

problem.

>I sure would love one of Saul's fiberglass units but not able to yet!

>Best wishes and much love, Ken

>

>Ken Gullan

Link to comment
Share on other sites

Ken,

Regarding the water leakage. Get a medium to heavy weight polyethylene

sheet and some 2x2 or 2x4 lumber. Cut the lumber to size to build a

rectangular frame with an inside measurement about an inch or two bigger

than the sauna. Just lay out the lumber to form a frame (you should

screw the corners together for stability) and lay the poly sheet over

the frame. Now place the sauna over the sheet/frame combination. This

will create a " bathtub " under the sauna with the sides of the tub being

the lumber. Should keep the floor dry.

BTW, I looked into washing machine trays but they are too small for the

Dens sauna.

Dennis

Ken Gullan - IRI wrote:

>I have done over 300 saunas in Den's sauna with the " junk " boiler and found it

to be adequate. the only complaint I have is that sometimes the steam can

direct itself directly onto your butt and can burn and the leakage through the

bottom of the tent can cause damage to a carpet. I have bought one of those

trays for under a washing machine and cut the poles so that it fits into the

tray, making life much simpler. Also, several towels on the bottom can ease the

problem.

>I sure would love one of Saul's fiberglass units but not able to yet!

>Best wishes and much love, Ken

>

>

>

>

Link to comment
Share on other sites

I cut the support pipes to get it to fit the tray. Only makes it look looser

bu5t has not negative effect on the quality of the sauna. I actually like it

better to dis-assemble and rebuild!

Best wishes and much love, Ken

Ken Gullan

Institute for Research Integration (IRI)

San Diego, CA 92106-2424

IRI is a 501C(3) non-profit corporation established to help children with

developmental difficulties.

To contact me off-list use kengullan@... or call 619-222-1104

Re: Re: Tent Sauna Thermostat

Ken,

Regarding the water leakage. Get a medium to heavy weight polyethylene

sheet and some 2x2 or 2x4 lumber. Cut the lumber to size to build a

rectangular frame with an inside measurement about an inch or two bigger

than the sauna. Just lay out the lumber to form a frame (you should

screw the corners together for stability) and lay the poly sheet over

the frame. Now place the sauna over the sheet/frame combination. This

will create a " bathtub " under the sauna with the sides of the tub being

the lumber. Should keep the floor dry.

BTW, I looked into washing machine trays but they are too small for the

Dens sauna.

Dennis

Link to comment
Share on other sites

> Dick,

>

> Is the " fast response remote bulb temperature controller " a

special kind

> of thermostat? I have found some remote bulb thermostats but I'm

not

> sure about the fast response aspect.

Not sure about the actual reaction time on others, but the one I

have reacts in about 5 sec. or so....

>

> I agree that the steamer is cheaply made but did you find that it

didn't

> do the job?....Not enough steam?

>

> Is the 6 gal electric water heater you use an off the shelf

product?

>

I don't know, all I know is that when I was looking for a steamer,

Den would not sell me one because he had so many problems with them.

They came from China, and he had a hell of a time with warranties.

The 6 gal. water is an off the self item. About a hundred bucks. If

you burn out the element, it is a 8 dollar fix from any hardware

store.

Dick

Dick

Link to comment
Share on other sites

> I have done over 300 saunas in Den's sauna with the " junk " boiler

and found it to be adequate.

The " junk " quote originated from Den at the point in time I tried to

buy one from him Kenney, about 2 years or so ago.

Dick

Link to comment
Share on other sites

Dick,

Who is the manufacturer of your 6 gallon steamer?

Where did you buy yours?

Thanks,

Dennis

>

>The 6 gal. water is an off the self item. About a hundred bucks. If

>you burn out the element, it is a 8 dollar fix from any hardware

>store.

>

>Dick

>

>Dick

>

>

>

>

Link to comment
Share on other sites

> Dick,

>

> Who is the manufacturer of your 6 gallon steamer?

>

> Where did you buy yours?

>

> Thanks,

>

> Dennis

Intertherm. It is a plain water heater, I modified it to be a

steamer. I bought it from one of my customers about 10 years ago and

never hooked it up until I had a need for it with the sauna. Looking

around on the internet, they are considerably more then a 100 bucks

nowadays.

Dick

Link to comment
Share on other sites

Join the conversation

You are posting as a guest. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...